3d Max to solidworks

Discussion in 'SolidWorks' started by Bryan Solace, Jun 25, 2004.

  1. Bryan Solace

    Bryan Solace Guest

    Has any one had any luck bringing in a file from 3d max 6 to SolidWorks.
    Have not had any luck with the .stl export.
     
    Bryan Solace, Jun 25, 2004
    #1
  2. Bryan Solace

    Sporkman Guest

    Try bringing it into Rhino3D, and from there into SolidWorks.

    Mark 'Sporky' Stapleton
    Charlotte, NC
    www.h2omarkdesign.com
     
    Sporkman, Jun 25, 2004
    #2
  3. Bryan Solace

    Paul Salvador Guest

    It would only fail if the STL is not valid, that is, it's not a closed
    (water tight) volume.
    So, there maybe a open seam or a facet failed to close?
    I'm not sure if Max has repair or check tools but maybe if you reimport
    the STL file you could check it?

    ...
     
    Paul Salvador, Jun 25, 2004
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Where find selection set max

  2. max filename length?

  3. LCD monitor for CAD, max, and maya

  4. measure max gm in a mosfet simulation

  5. max size of mdl application (insufficient memory loading mdl app.)

  6. MAX NUMBER WINDOWS

  7. Converting an Surface Imported from 3D Studio Max into a Solid

  8. Export to 3d Studio Max

Loading...