2D drawings - Surface body

Discussion in 'SolidWorks' started by JRat, Jun 13, 2006.

  1. JRat

    JRat Guest

    Is it possible to create sectional view of a "Surface body" in 2D
    drawing?


    SW 2006, SP5.0
    Thanks,
    J.Rathakrishnan
     
    JRat, Jun 13, 2006
    #1
  2. JRat

    mjlombard Guest

    No.

    The closest you can come is to trim the surface where you want to
    section it and make a drawing of that.
     
    mjlombard, Jun 13, 2006
    #2
  3. JRat

    Sam Guest

    You can use the thicken feature to thicken the surface body which in
    turn will be cut by a section line in a drawing.

    Sam
     
    Sam, Jun 13, 2006
    #3
  4. JRat

    JRat Guest

    Basically, we are building light weight models for our heavy
    equipements to use it for Plant Engineering. Surface Body parts are
    less in file size than Solid Body parts. But the only BIG issue is I
    couldn't make any section views of that. Even Surface Bodies are not
    appeared in a section view eventhough the section line is not cutting
    that body.

    Thanks,
    JRat
     
    JRat, Jun 13, 2006
    #4
  5. JRat

    JRat Guest

    I am very happy Paul, to see a reply from you. I realy inspired by your
    web site zxys.
    Sure Paul, I will send an ER to SolidWorks now.

    SW2005, SP5.0
    JRat
     
    JRat, Jun 14, 2006
    #5
  6. JRat

    JRat Guest

    Refer below, there are already few ERs (2 and 3) related to my post.
    However I have also registered my suggestions in SoildWorks Enhancement
    Request forum.

    Thanks,
    JRat
    Enhancement Requests

    Step 2: Common Enhancements

    Here are some common requests that match the keywords you selected.
    Select the one that most closely matches your request (if any).

    (Note: You can add comments and/or attach files on the next page.)

    1. When you delete a section or detail view; the lettering scheme skip
    that letter on future created section or detail view.

    2. Can not create section views of surface bodies

    3. Displaying surfaces when creating a section view in a drawing

    4. Ability to create sectioned Isometric views.
     
    JRat, Jun 14, 2006
    #6
  7. JRat

    mjlombard Guest

    In the model, you can do a Section View and the surface previews as
    cut, but when you accept the section, the surface reverts to being
    un-cut. That's one that frustrates me big time. Plus, you can't
    select surfaces when in section view mode.
     
    mjlombard, Jun 14, 2006
    #7
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.