2006 SP5 pos

For the 3rd time now in the 2 days since I installed SP5 I'm getting
"Failed to save document" error when trying to save my assembly. Guess
I'll close out again and re-do whatever I just did since the last
successful save. Going to roll back to SP4 next week unless I take a
chance & install 2007. Anyone else notice this problem w/ SP5?

 

haven't seen the problem here.

bill

 

Are you working off the network?

Best Regards,
Devon T. Sowell
www.3-ddesignsolutions.com

 

We have a small network, no server & all my files are local on my
computer

 

I'm not noticing the 'fail to save error', but i did notice on two of
my installations that since SP5.0, i get incorrect shaded display, when
i bring something that hidden back to 'show' status. surfaces are
see-thru, and highlight faces shows boundaries skewed somewhere else in
space, very annoying graphical issues. hitting rebuild fixes it up,
but still, this never happened before.

just re-inforces my commitment to CANCEL our subcription service for 1
year to see if SolidWorks can get its head out of its own arse and put
quality ahead of new useless features.

 

(Resending this)

I have seen that in the past, but I don't know that I can tie it to SP5. I
think I have seen it longer ago than SP5 has been available, but not sure. I
had always surmised that it was somehow tied to a network communication
error, since the files are generally in our PDM system.

WT

 

Check your disk space, clear your temp directories and call me in the
morning

Corey

 

Just had the pb once this morning. After a few trials ended with a crash.