2005sp0.1 - SW BOM, Configs, & Balloons

Discussion in 'SolidWorks' started by wc, Mar 7, 2005.

  1. wc

    wc Guest

    We've got an assembly we created back in SWX2003 and have used and
    modified since, it has a number of subassemblies and a number of
    configurations.

    When trying to apply Balloons to the Assembly, items in the Sub-Assy's
    of all configs except Default show as an Asterisk, or their individual
    Item Number(depending on which settings I choose)- even though the BOM
    is showing the SubAssy (ie- balloons will show either '*' or '86' even
    though the BOM goes only up to 31.

    I've checked that all the configs are matching between the drawing
    views, BOM, and Assy. Also the only Config that seems to work as
    expected is the Default.

    Any suggestions on where I should look to fix this problem?

    Thanks
     
    wc, Mar 7, 2005
    #1
  2. wc

    wc Guest

    Aha!

    SPR#234629 “Flexible sub assemblies show balloons with an asterisk (*)
    rather than part number.” was fixed in service pack 1.1!

    dingdingding!


    proceed.
     
    wc, Mar 8, 2005
    #2
  3. wc

    Richard Charney Guest


    And he wins a cigar! Or a rubber cookie, it's your choice.
     
    Richard Charney, Mar 8, 2005
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Bom Balloons / Repeat regions

  2. Deleting BOM table without deleting BOM balloons

  3. BOM balloons

  4. spline on surface problem 2005sp0.1

  5. SW BOM and Balloons

  6. Multiple configs in BOM for parts on a drawing

  7. BOM & Balloons not matching?

  8. SW BOM - multiple configs - all parts

Loading...