· Utilize redefine and exist within fail mode

Discussion in 'Pro/Engineer & Creo Elements/Pro' started by cnachane, Jul 18, 2006.

  1. cnachane

    cnachane Guest

    Whenever a feature generation fails ,I am not able to manipulate the
    model to correct the feature.I always say rollback and start all over
    again.How to use · Reorder/ Reroute in detail,
    can any one please explain this to me?
     
    cnachane, Jul 18, 2006
    #1
  2. cnachane

    Walther Mathieu Guest

    It´s a good idea to have _two_ instances of ProE side by side
    (two seats with floating license), to compare with an undemolished
    (older) model on one of them during redefine/reroute/reorder surgery.

    Esp. when the model is big/complex and dependencies not remembered,
    comparison of features and "lost" referrences is quite helpful.

    Walther
     
    Walther Mathieu, Jul 19, 2006
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Fail to create object

  2. objectdbx and redefine block

  3. Redefine block - retreiving and passing block name.

  4. entsel, fail, use fail-point for crossing/fence

  5. How to open Layout in Turbo mode, w/ DRD on in "Notify" mode ??

  6. To Exist or Not to Exist

  7. Best way to fully utilize the power of Solidworks

  8. Can 2002 and 2004 Licenses co-exist?

Loading...